Seiko 2320 Quartz Movement | 364 SR621SW Battery & 2320A Technical Data
The Gilded Hour technical archive · Historical quartz and mechanical watch references · Research reviewed 21 November 2026
Seiko 2320 is a small-format vintage analogue quartz movement, documented in the Seiko 2320A factory service material. The movement is notable for its eight-jewel construction and 20-second stepping action. It appears in compact vintage dress watches including examples held in The Gilded Hour's archive.
The calibre catalogue and specialist Seiko references identify a 364-type low-drain silver-oxide cell. Confirm the fitted battery, contact and insulator before replacing a vintage cell.
Technical snapshot
| Calibre family | Seiko 2320 / documented 2320A revision |
|---|---|
| Movement type | Analogue quartz, two-hand display |
| Battery cross-reference | 364 / SR621SW (secondary movement reference) |
| Nominal battery dimensions | 6.8 × 2.15 mm (Seiko Instruments) |
| Published movement dimensions | 15.1 × 13.0 mm (2320A service document) |
| Maximum movement height | 2.5 mm without battery (2320A service document) |
| Jewels | 8 (2320A service document) |
| Quartz oscillator frequency | 32,768 Hz |
| Driving system | Two-pole stepping motor; 20-second hand-step interval |
Specifications here are tied to the sources listed below. The physical watch, exact calibre suffix and movement engraving control a service decision.
Battery and calibre identification
Separate the battery specification from the physical movement geometry. The factory 2320A material gives its 15.1 × 13.0 mm casing dimensions and identifies a silver-oxide power cell. The 364 / SR621SW identification is supported by specialist movement listings and contemporary Seiko reference resources.
A modern 364 battery has a nominal diameter of 6.8 mm and thickness of 2.15 mm. Check that the original holder, insulator and case clearance are intact rather than treating nominal diameter as a complete fit test.
How the movement works
The 2320A documentation describes a two-pole step-motor system, a 32,768 Hz quartz oscillator and rotary-step-switch regulation. It also instructs watchmakers to allow sufficient time when measuring current because the calibre advances at 20-second intervals rather than making a visible one-second tick.
This unusual timing should not be mistaken for a fault without considering the technical specification and actual hand position.
Examples in The Gilded Hour archive
These are watches whose existing catalogue records identify this calibre. A listing attribution is not itself factory proof of the installed movement; refer to the individual watch record and original photographs for confirmation.
- Seiko Champagne Dial Soft Hexagonal Women’s Watch
- Seiko Champagne Cushion White Accent Women’s Watch
Documentary movement photograph: not yet added for this calibre. We do not substitute a fabricated illustration or infer engravings from the watch exterior.
Service and parts cautions
Use the correct 2320 or 2320A parts list rather than treating all 23xx Seiko variants as interchangeable. In the original technical drawing, the circuit block, battery contacts, stator, step rotor and wheel bridge are distinct service components. An overly aggressive battery or contact repair can damage the circuit and insulation.
Factory service documents are technical references for trained watchmakers, not an instruction to dismantle a functioning vintage watch.
Sources and verification
- Seiko 2320A scanned factory service/parts document — Casing dimensions, jewel count, step motor and electrical service context
- The Seiko Guy technical archive — 2320 calibre and SR621SW battery cross-reference; archived technical scans
- Mizeni Seiko 2320 specification index — Secondary check of dimensions, oscillator and 364 battery
- Seiko Instruments battery chart — 364 / SR621SW dimensions
The Gilded Hour is an independent technical archive, not an official service department for Seiko. Quoted values are source-linked; original manuals remain on their respective publishers' websites. Replacement batteries and parts must be checked on the actual movement.